MUC-OFF BIKE ULTIMATE TUBELESS SETUP KIT

The Muc-Off Ultimate Tubeless Kit contains everything needed to get a tubeless-ready wheelset set up and ready to roll. Each Kit contains a Muc-Off Tubeless Rim Tape, Seal Patches, 2 CNC-machined black tubeless Valves and 2 pouches of No Puncture Hassle Tubeless Sealant.

Our kit options:

• Road (21MM TAPE / 44MM VALVES)
• Road (21MM TAPE / 60MM VALVES)
• XC/Gravel (25MM TAPE / 44MM VALVES)
• DH/Trail/Enduro (30MM TAPE / 44MM VALVES)
• DH/PLUS (35MM TAPE / 44MM VALVES)

HOW TO USE

1. Remove all old rim strips or tape and clean the rim.
2. Make sure the rim is clean and dry before applying tape.
3. Get the tape from the packet and line it up from the opposite side of the valve.
4. Start by unwinding a small amount of the tape and pressing it down using your thumb or finger to hold the pressure down.
5. Continue to hold while you pull back on the tape and stick down tight once you have a few cm on the tape will stick and holding is no longer needed.
6. Continue the entire way around the rim (if it has a big concave in you can pull and wiggle the tape to fill any edges)
7. Overlap the tape by roughly 10 – 15cm
8. Leave a small amount unstuck so that you can cut the remainder off
9. Once cut sketch and pull the tape down to create a seal
10. Go around the rim with your thumb to make sure there is no air pockets or messed areas.
11. Once you are happy with how it looks using a small pin locate the valve hole and cleanly pierce the tape ready for the valve
12. Grab your tubeless valve and remove the lock ring and o ring
13. Chose the right rubber fitment for your rim tape and insert the valve into the rim
14. Refit the O-ring and Lock ring making sure you lock the valve in (don’t go to tight or it could damage the rubber)
15. Re-fit your tyre of choice careful not to damage the tape (by using tyre levers etc.)
16. Inflate tire to create a fit (you should hear some popping around the rim)
17. Release the Air and remove valve core using the spare valve cap
18. Grab the sealant pouch and give it a shake
19. Unscrew the cap and fit on the valve in an upright position
20. While holding the pouch spin the wheel downward so that the pouch is now upside down
21. Insert the sealant by rolling the pouch down
22. Spin the wheel back upright and remove the pouch
23. Reinsert the valve core and inflate to your pressure

Size Guide